You are browsing the forum as a guest. Log in or register to access additional features.
DailyDrivenTJ.com Forum Index

2108287 visitors since May 16, 2006

DailyDrivenTJ.com
Register  ::  Log in Log in to check your private messages.


This forum is locked: you cannot post, reply to, or edit topics.  This topic is locked: you cannot edit posts or make replies.
 Bone head move.. « View previous topic :: View next topic » 
Author Message
SilverXJ
PostPosted: Fri Mar 16, 2007 8:53 pm    Post subject: Bone head move.. Reply with quote

Newbie
Newbie

Joined: 17 Feb 2007
Posts: 26

When I installed my brakes I had to use a pre-'99 hub and the associated bracket on one side. I finally got around to installing my new hubs today. So, I was putting the rotor and caliper back on after swapping hubs and for some reason the caliper is really tight on the rotor. So, I'm trying to shove the caliper and bracket on (removed it as a pair) and I release the lug nut holding the rotor on. The caliper then goes on easily while pushing the rotor out about 5mm. 5mm is the difference between the pre-99 and 2000+ bracket.

After all that I forgot to change back to the 2000+ bracket with the 2000+ hub. Blah.

PIA. At least my lifter replacement went smooth.

-Chris
Back to top
Display posts from previous:   
This forum is locked: you cannot post, reply to, or edit topics.  This topic is locked: you cannot edit posts or make replies. Page 1 of 1

Jump to:  



Jeep, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Daimler-Chrysler Corporation.
DailyDrivenTJ.com is not associated with the Daimler-Chrysler Corp. in any way.
Copyrighted (c) 2006 DailyDrivenTJ.com - All right reserved.
Template Based on DAJ Glass (1.0.8) by Dustin Baccetti
DailyDrivenTJ.com Logo Designed by Michael Kang
Powered by phpBB © 2001, 2005 phpBB Group